FREE UK MAINLAND DELIVERY ON ORDERS OVER £50
Particularly where large bearings are involved, it is often necessary to make provisions during the bearing arrangement design stage, to facilitate mounting and dismounting of the bearing, or even to make it possible at all. If, for example, slots or recesses are machined in the shaft and/or housing shoulders, it is possible to apply withdrawal tools (fig 1). Threaded holes in the housing shoulders also enable the use of screws to push the bearing from its seat (fig 2).
If the oil injection method is to be used to mount or dismount bearings on a tapered seat, or to dismount bearings from a cylindrical seat, it is necessary to provide ducts and grooves in the shaft (fig 3). The distance of the oil distribution groove from the side of the bearing from which mounting or dismounting is to be undertaken should be about one third of the seat width. Recommended dimensions for the appropriate grooves, ducts and threaded holes to connect the oil supply can be found in table and table.
All trademarks, logos and brand names used on this website are the property of their respective owners. All company, product and service names used in this website are for identification purposes only. Use of these names, trademarks and brands does not imply endorsement.
bearingswebshop.com is a trading name of 1T Solutions Limited bearingswebshop.com
© 2008 – 2025 1T Solutions Limited. All Rights Reserved.
Disclaimer:
Errors and Omissions Excepted.
Any dimensions, tolerances or performance figures shown on this website and any associated documents are for guidance only. For factual figures, reference should be made to the current edition of the appropriate standards where applicable.
Every effort is made to keep the information on this website accurate and up to date. However, bearingswebshop.com accepts no responsibility for errors or omissions or for any third party loss or consequences arising from what is published.
The information within this website is based on our present knowledge and experience, and is supplied in good faith.
No liability is accepted by bearingswebshop.com. in respect of any action taken by a third party.
The products detailed on this website may be used for a variety of purposes and as bearingswebshop.com has no control over their use. bearingswebshop.com excludes all conditions and warranties expressed or implied by statue or otherwise, as to dimensions, properties and/or their suitability for an application.
